Using The Lcd Display; Setting The Timing Mode; Osd And Power Lock Settings - ViewSonic VA2753S User Manual

Using the LCD Display

Setting the Timing Mode

Setting the timing mode is important for maximizing the quality of the screen image
and minimizing eye strain. The timing mode consists of the resolution (example
1024 x 768) and refresh rate (or vertical frequency; example 60 Hz). After setting
the timing mode, use the OSD (On-screen Display) controls to adjust the screen
image.
For optimal picture quality, please use the recommended timing mode specific to
your LCD display listed on the "Specification" page.
To set the Timing Mode:
• Setting the resolution: Access "Appearance and Personalization" from the
Control Panel via the Start Menu, and set the resolution.
• Setting the refresh rate: See your graphics card's user guide for instructions.
IMPORTANT: Please make sure that your graphics card is set to 60Hz vertical
refresh rate as the recommended setting for most LCD displays. Choosing a non-
supported timing mode setting may result in no image being displayed, and a
message showing "Out of Range" will appear on screen.

OSD and Power Lock Settings

• OSD Lock: Press and hold [MENU] and the right arrow
other buttons are pressed the message OSD Locked will display for 3 seconds.
• OSD Unlock: Press and hold [MENU] and the right arrow
seconds.
• Power Button Lock: Press and hold [MENU] and the left arrow
seconds. If the power button is pressed the message Power Button Locked will
display for 3 seconds. With or without this setting, after a power failure, your LCD
display's power will automatically turn ON when power is restored.
• Power Button Unlock: Press and hold [MENU] and the left arrow
10 seconds.
► for 10 seconds. If any
►
6
again for 10
◄ for 10
◄ again for