Preparing The Multi Cradle And Power Supply; Multi Cradle (Ac Adaptor) - Panasonic DVD-LX9 Operating Instructions Manual

Preparing the multi cradle and power supply

BEFORE USE
Remove the
insulation sheet
Make sure the built-in battery is attached
whenever you use the unit.

Multi cradle (AC adaptor)

1
Unwind speaker wire,
then fit the wire back
into the groove of the
speaker base.
2
Twist and pull off the vinyl tip.
3
Connect the speakers.
COMPONENT VIDEO OUT
(480P/480I)
+
Y
SPEAKER
HAUT
PARLEUR
4≠
-
R
Push the levers and insert the wires.
Light gray
Dark gray
Caution
Use the speakers only with
the recommended system.
Failure to do so may lead to
damage to the connected
equipment and/or the
speakers, and may result in
the risk of fire. Consult a
qualified service person if
damage has occurred or if
you experience a sudden
change in performance.
12
DC IN 9V
S VIDEO AUDIO OUT 5.1ch VIDEO
OUT OUT
2ch (MIX) +
SUB
P P WOOFER CENTER SORROUND FRONT
B R
SPEAKER
HAUT
PARLEUR
4≠
-
L
R L R L
No line
Black line
4
Attach to cradle.
(When the unit is off)
Make sure built-in battery
is attached.
Ë
DC IN 9V
DC IN
When using only the player
Connect the AC adaptor directly to the player's
DC IN terminal.
The unit is in the standby condition (the [Í]
indicator lights) when the AC power supply
cord is connected. The primary circuit is
always "live" as long as the AC adaptor is
connected to an electrical outlet.
≥To conserve power
When the unit is not going to be used for a long
time, disconnect the AC power supply cord from
the AC outlet.
The unit consumes a small amount of power
(approx. 0.9 W, when in the multi cradle) when
in standby mode.
∫ To detach
(When the unit is off)
Pull the lever so the unit lifts off the cradle.
2
DC IN
Household AC outlet
(AC 120 V, 60 Hz)
AUDIO
VIDEO
OPT OUT
SD CARD : PUSH RELEASE
RELEASE
1
Fit so unit
clicks firmly
into place.