DeVilbiss GT5251-1 Operator's Manual page 10

GBE4010
FOR AND
5. Remove the nut from the solenoid
post with the panel assembly wire
harness. Place one end of the posi-
tive (red) battery cable onto this
post with the panel assembly wire.
Reassemble nut and tighten
securely. See Figure 4.
GBV7000, GBV7010,
FOR
GBVE8000
5. Remove the nut from the solenoid
post and place one end of the posi-
tive (red) battery cable onto the
post. Reassemble nut and tighten
securely. See Figures 5.
two terminal configurations. The
Positive (+) and Negative (-) terminals
can be oriented so that they are +/- or
-/+. See Figure 6. In the unlikely event
that the battery terminals are un-
marked, we recommend that you
return the battery to the retailer for
exchange for a properly marked
battery or let an authorized service
center install the battery for you.
Failure to connect the battery
properly can possibly cause bodily
injury. In addition, extensive engine
electrical damage not covered under
warranty can result.
6. Attach the other end of the positive
(red) battery cable to the positive (+)
terminal on the battery.
(positive) cable to the positive (+)
terminal before connecting the black
negative cable.
7. Attach one end of the negative
(black) cable to the negative (-)
terminal on the battery.
8. Attach the other end of the negative
(black) cable to the frame as
shown. Install the star washer be-
tween the cable and the frame. See
Figure 7.
D25572
GBFE6010
Lawn & Garden
batteries can come in
To Prevent sparks
connect the red
Solenoid
IMPORTANT: See Figure 6 caution
before connecting cable to battery.
Star Washer
(-) Negative Battery Cable Connection
10- ENG
Solenoid
Assembly
Harness
Figure 4
Nuts
Positive (+)
Battery Cable
Figure 5
Figure 6
Negative (-) Negative (-)
Battery Cable Battery Cable
Figure 7
Panel
Wire