Hoshizaki SRC-14H Service Manual page 30

7) Press the actuator paddle located in the top of the chute.
S1 dip switch 7 in the "ON" position: PDS and GM de-energize and CB sounds a
9-beep alarm.
S1 dip switch 7 in the "OFF" position: PDS and GM de-energize.
BC(2) Diagnosis: If BC(2) does not open or the icemaker continues to make ice, check
that the actuator paddle is moving freely. Confirm that the actuator paddle is engaged.
Check for continuity across BC(2) wires. If BC(2) contacts are found open and the
icemaker continues to make ice, replace CB. If BC(2) is closed with the actuator paddle
engaged, replace BC(2).
8) Move the power switch to the "OFF" position, then unplug the appliance from the
electrical outlet.
9) Replace the chute assembly and strap in their correct positions.
10) Replace the control box cover and top panel in their correct positions.
11) Plug the appliance into the electrical outlet.
12) Move the power switch to the "ON" position to start the automatic icemaking process.
13) Replace the front panel in its correct position.
Legend: BC–bin control (mechanical stand-alone); BC1–bin control 1 (infrared sensor);
BC2–bin control 2 (mechanical backup); CB–control board; GM–gear motor;
PDS–pump-down solenoid valve
30