Table of Contents
Advertisement
en
Fault, what to do?
Fault
Rust spots on the cutlery.
Appliance does not start.
Programme starts
automatically.
The door is difficult to
open.
Door cannot be closed.
Cover on the detergent
dispenser cannot be
closed.
Detergent residue in the
detergent dispenser or in
the tablet collecting tray.
34
Cause
Cutlery not adequately rust-
resistant. Knife blades are
frequently more severely
affected.
Cutlery will also rust if rusting
parts are rinsed at the same time
(pan handles, damaged utensil
baskets, etc.).
Salt content in the rinsing water
too high, as salt dispenser lock
not fastened firmly or salt was
spilled while being refilled.
The mains fuse has tripped.
Power cord not inserted.
The appliance door has not been
shut properly.
You did not wait until programme
ended.
Child lock is activated.
Door lock has been activated.
Door cannot be closed due to
installation.
Detergent dispenser or cover
guide blocked by sticky detergent
residue.
Spray arms blocked by utensils,
therefore detergent is not rinsed
out.
The detergent dispenser was
damp when filled.
Remedial action
Use corrosion-resistant cutlery.
Do not wash rusting parts.
Fasten salt dispenser lock firmly or remove
spilled salt.
Check mains fuse.
Ensure that the power cord is plugged all
the way into the back of the appliance and
into the socket. Check that the socket
functions.
Close the door.
Perform reset.
(See "Terminating the programme").
Deactivate child lock. (See instructions for
use at the back)
Close door with increased force.
Check appliance installation: Door
or attached parts must close without
obstruction.
Remove detergent residue.
Ensure that the spray arms can rotate freely.
Pour detergent into the dry detergent
dispenser only.
Advertisement
Table of Contents
