Table of Contents
Advertisement
Advanced Picture Menu
You can adjust the gaps in color that have occurred after a long period of use.
Notes
• Auto Calibration results in relatively coarse calibration. The color settings are not guaranteed to be the same as the factory default values.
• The colors are projected automatically while performing "Pre Check" or "Adjust." This is not a malfunction.
• Do not turn off the power or operate the remote control or control panel during "Pre Check" or "Adjust," as the process may be canceled.
Tips
• dE is an indicator of changing color. The smaller the value of dE, the fewer the changes caused by the color.
• Perform the calibration after the power has been on for more than 30 minutes.
• It takes a few minutes for "Pre Check" or "Adjust" to complete.
• When "Pre Check" or "Adjust" starts, the screen position may shift as the lens returns to its factory default position. After completion, the
screen returns to its previous position automatically.
• If the environment, such as the brightness of the room, changes while performing "Pre Check" or "Adjust", measurement may be affected.
• If the "Pre Check" or "Adjust" function fails, try it again.
Setting items
Auto Calibration
Description
Pre Check: Checks the color difference against the factory default settings, before calibration starts.
Adjust: Performs Auto Calibration.
Before/After: Toggles the factory default settings and the setting after the calibration at a certain
frequency. You can check the effect of the calibration by monitoring the actual image.
Reset: Resets the calibration results, and returns to the factory default settings.
22
Advertisement
Table of Contents
