Advertisement
Installation:
1.
Screw in the studded rod (E) into the base of the tap (A).
2.
Place the base plinth (B) then upper seal (C) onto the base of the tap (A).
3.
Screw the hot & cold water tail pipes (D) into the base of the tap.
4.
Place the mixertap (A) onto the sink or worktop, pass the tail pipes (D) and studded rod (E) through the taphole.
5.
Pass the rubber and then metal horseshoe (F&G) over the studded rod (E) and around the tail pipes.
6.
Fasten the fixing nut (H) securely onto the fixing stud (E) to fix the tap into its correct location.
7.
Connect the hot and cold tail pipes (D) to the water mains using a ½" BSPx15mm compression fittings.
Key:
Description:
A
Mixertap body
B
Base plinth
C
Upper seal
D
Hot & cold rigid tail pipes
E
Fixing stud
F
Rubber horseshoe
G
Metal horseshoe
H
Fixing nut
After installation:
Once you have visually checked the new fittings and connections, ensure that all taps are closed except the new mixer tap, which should be
left open. Turn on the water supply at the mains stop cock. As the system starts to refill, check carefully for leaks. Once you are fully
satisfied that there are no leaks, turn on the water heating.
Clean the tap to remove any marks created during installation as instructed then replace the bag that has been provided to protect the tap
until it is ready for use.
Qty
1
1
1
2
1
1
1
1
Advertisement
