Table of Contents
Advertisement
General
WARNING! Prevent unintentional
!
starting by removing the ignition cable
from the spark plug.
CAUTION! This lawn mower is shipped without oil or
gasoline in the engine.
Remove the lawn mower from the
carton
•
Remove loose parts included with mower.
•
Cut down two end corners of carton and lay end panel
down flat.
•
Remove all packing materials, except padding
between upper and lower handle and padding holding
the operator presence control bar to upper handle.
•
Roll the lawn mower out of the carton and make sure
that no loose parts are left within the carton.
Handle
CAUTION! Take care not to damage the cables and
wires when you unfold the handlebar.
Operating position
1
Raise the lower handle section to operating position.
Align the handle bar pins with a slot in the handle
bracket to set a comfortable height position for the
handle.
2
Tighten the lower handlebar screws.
3
Remove protective padding, raise the upper handle
section into place on the lower handle and tighten
upper screws.
4
Remove any packing material from around operator
presence control bar.
10 – English
ASSEMBLING AND ADJUSTMENTS
Storage/Transport position
The handle assembly can be folded to minimize space
needed for transport and storage.
CAUTION! Take care not to damage the cables and
wires when you fold the handlebar.
The handle can be set in a vertical storage position.
1
Remove the lower handle screws.
2
Remove the 2 top screws on the top handle and
loosen the 2 lower screws on the top handle.
3
Rotate the lower handle forward and fold the top
handle carefully backwards and let the handle
assembly rest on the mower.
13
Advertisement
Table of Contents
