Advertisement
INSTRUCTION MANUAL
Model: MSL155
Lamps: 1 FT55DL Lamp
Ballast: Electronic, high frequency, SS
Reflector: 95% specular reflectance
Voltage: 120, 230, 277 50-60 Hz
Manufacturer: PL Systems, Inc.
Address: 10529 Olympic Drive, # 102
Dallas, TX 75220
(214)-393-5998 (voice)
(214)-393-5999 (fax)
e-mail: info@kw2.com
Web page: KW2.com
GENERAL INFORMATION
Thank you for your selection of one of our most effective studio luminaires, the MSL155. This high
luminaire should provide many years of low cost operation. The MSL155 is designed
performance
to maximize "throw" or "punch" by collimating the light while remaining "cool" and minimizing shadows.
Unwanted spill is controlled with optional egg crates or honeycomb. The luminaire provides a mounting
slot for attaching gel frames and/ or honeycombs and egg crates. The SL series is as close as fluorescent
can come to a key light.
All PrimeTime Studio Lights are equipped with advanced reflector technology.
The MSL155 is available in standard full power (non-dimming), Voltage dimming, analog signal dimming
(0-10 volts) and full DMX-512 discrete dimming (1 luminaire per channel). This degree of availability
provides for compatibility with most current control scenarios.
The MSL155 is made of welded aluminum and powder coated in non-reflective black. Accessories are
made of aircraft alloy aluminum. Standard luminaires are equipped with detachable 10' long power
cords. Each 120 volt cord is equipped with Edison 3 prong connectors. Other voltage models are
shipped without plug unless specified. A fused power in and out receptacle is supplied for
120 volt models. Adjacent fixtures may be powered with this connector so long as the load does
not exceed 800 watts. (fig. 2) The switch controls the power to the one fixture. Power to a luminaire
is indicated when the switch is lit.
The MSL155, like most of the line, is mountable in horizontal or vertical orientation. Ordinary grip
devices allow stand mounting as well.
For instructions on dimming models see dimming addendum.
msl1omp1.ai
fig. 1
p 1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Primetime MSL155
- Page 1 Web page: KW2.com fig. 1 GENERAL INFORMATION Thank you for your selection of one of our most effective studio luminaires, the MSL155. This high luminaire should provide many years of low cost operation. The MSL155 is designed performance to maximize "throw" or "punch" by collimating the light while remaining "cool" and minimizing shadows.
- Page 2 1. Fresnel reflector exhibits 95% specular reflectance. Spectral response is unchanged over the visible range. 2. The MSL155 is fitted with one twin tube 55 watt studio lamp, in several colors and CRI. See table 1. 3. Lamp retainers locate and hold lamps securely. See "Lamp Installation".
- Page 3 INSTALLATION: Remove the luminaire from the shipping carton and inspect for any damage during shipping. If attenuators are ordered they may be installed in the aperture. If so, loosen the accessory slot cover retaining screws and slide the cover back to expose the slot. Remove the accessory to install the lamps which are shipped separately.
- Page 4 If you have any questions call (214)-393-5998. CAUTION: ALWAYS DISCONNECT POWER BEFORE CLEANING THE LUMINAIRE PrimeTime L i g h t i n g S y s t e m s Manufactured in the USA by: PL Systems, Inc.
- Page 5 FUSE REPLACEMENT FOR FIXTURES WITH DETACHABLE POWER CORDS. spare active fuse DIRECTIONS Fixtures equipped with detachable power cords contain fuses which are rated at ten amps @ 250 Vac. To replace fuse remove power cord exposing the receptacle as shown in figure A.
Need help?
Do you have a question about the MSL155 and is the answer not in the manual?
Questions and answers