Samsung DVEG50R8500 Series User Manual page 30

Installation
If the Y-connector cannot be directly connected to the cold water tap, use the short hose.
See the "Using the short hose as an extension" section on page 31.
30 English
Untitled-2 30
4. Connect the angled end of the water
hose to the filling valve at the bottom
rear of the dryer. Turn the coupling by
hand until it is tight.
5. Using pliers, tighten the coupling an
additional two-thirds turn. Do not
overtighten. You can damage the
coupling.
6. If you detached the cold water hose
from your washer, attach the hose
to the open end of the Y-connector,
tighten the coupling by hand until it is
tight, and then, using a pliers, tighten
an additional two-thirds turn.
7. Open the cold water tap, and then check
for any leaks.
2021-05-17 11:37:14