Table of Contents
Advertisement
2. Replacing Refrigerator Door
u u Right Door
• Lower the door onto the middle hinge pin (8). Make sure the door is aligned with the cabinet.
• Replace the top hinge by rotating the hinge lever (6) counter clockwise to secure hinge.
Make sure the gasket on the door is flush against the cabinet and is not folded. Support the door on
the handle side while securing hinge. Make sure the door is straight and the gap between the doors is
even.
• Install the ground screw (5) and connect the wire harness (4).
• Connect the door switch wire (2).
• Tighten the cover screw (1).
u u Left Door
• Lower the door onto the middle hinge pin(8). Make sure the door is aligned with the cabinet.
• Replace the top hinge by rotating the hinge lever (6) clockwise to secure hinge.
Make sure the gasket on the door is flush against the cabinet and is not folded. Support the door on
the handle side while tightening. And make sure the door is straight and the gap between the doors is
even.
• Insert the water supply tube (3) into the connector tube until you see only one scale mark.
(Fully insert the tube over 5/8"(15mm)).
• Install the ground screw (5) and connect the 3 wire harness (4).
• Connect the door switch wire (2).
• Tighten the cover screw (1).
w w CAUTION: Be careful of missing the washer[part (9)].
Because it can be easily taken off.
&
'
REFRIGERATOR INSTALLATION
10
Correct
Incorrect
&
'
Advertisement
Table of Contents
