Uncle Milton Industries Space Image Projector Instruction Manual

Time and space image projector

Table of Contents

Download this manual

BATTERY SAFETY INFORMATION

Batteries are small objects. Batteries must be replaced by an adult.

Follow the polarity (+/-) diagram in the battery compartment.

Promptly remove dead batteries from the toy.

Dispose of used batteries properly.

Remove batteries for prolonged storage.

Only batteries of same or equivalent type as recommended are to be used.

DO NOT incinerate used batteries.

DO NOT dispose of batteries in fire, as batteries may explode or leak.

DO NOT mix old and new batteries or types of batteries (i.e. alkaline/standard).

DO NOT use rechargeable batteries.

DO NOT recharge non-rechargeable batteries.

DO NOT short-circuit the supply terminals.

KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE — DO NOT DISCARD

Problems? Before taking this product back to the store, please contact us.

Call 1-888-742-2484 or go to www.unclemilton.com

Uncle Milton Industries, Inc. Westlake Village, CA 91362

of UMI. Printed in China.

™

are trademarks

2060-0607

Time and Space Image Projector

Instruction Manual

AGES 10 AND UP

2060

Table of Contents

Do you have a question about the Space Image Projector and is the answer not in the manual?

Page 1 Problems? Before taking this product back to the store, please contact us. Call 1-888-742-2484 or go to www.unclemilton.com ® Uncle Milton Industries, Inc. Westlake Village, CA 91362 © UMI. All rights reserved. Uncle Milton® and Night Sky Projector Clock of UMI. Printed in China.
Page 2: Important Safety Instructions
14. Damage requiring service or replacement: Unplug the product from the wall outlet and refer servicing to Uncle Milton Industries under the following conditions: A. When the power-supply cord or plug is damaged, B.
Page 3 Projector Time Projection On/Off Image Selector Dial Image Projection On/Off “Up” Adjustment Button also: selector for standard (12-hr) or military (24-hr) time “Down” Adjustment Button Alarm On/Off Speaker Alarm Set Button Date/Time Set Button Alarm Sounds Selector AC Adapter Jack input 120V AC, 60Hz output 6V DC, 450 MA Front...
Page 4: Using The Projector
Minute – Press DATE/TIME SET button again (minute will flash on LCD screen). Press [ ] “UP” ADJUSTMENT button or [ ] “DOWN” ADJUSTMENT button until correct minute appears on LCD screen. 2. Press DATE/TIME SET button again to exit the date/time set mode and return to normal mode.

Night sky