Preparations; Before Use - Panasonic LUMIX DMC-FZ300SG Basic Operating Instructions Manual

Before use

Care of the camera
To avoid damaging your camera and to experience the maximum enjoyment you
should exercise the following precautions.
●
The lens, monitor and the camera body can sustain damage if the camera body is
dropped or subjected to excessive temperature, moisture, water or dust.
●
The monitor can be damaged if excessive pressure is applied to the screen surface,
during actual use or while cleaning.
■
Splash Proof
Splash Proof is a term used to describe an extra level of protection this camera offers
against exposure to a minimal amount of moisture, water or dust. Splash Proof does
not guarantee that damage will not occur if this camera is subjected to direct contact
with water.
In order to minimise the possibility of damage please be sure the following precautions
are taken:
• Make sure the built-in flash is closed.
• Make sure that all doors are securely closed.
• Make sure that you are in a dry and secure place when changing the battery or
memory card. After changing, make sure their protective doors are securely closed.
• If this camera is exposed to water, sand or any other foreign material clean it as soon
as possible, taking the necessary precautions that the foreign substance does not get
inside the camera.
• Under no circumstances should you place any foreign objects within the camera.
If sand, dust, or liquids such as water droplets adhere to the camera, wipe them off with
a dry soft cloth.
• Not doing so may result in incorrect recognition of touch operations or erroneous
flash display.
• If the monitor is closed when such liquids are present, malfunction may result.
■
Condensation
●
Condensation may occur on the lens, monitor or in the viewfinder when the room
temperature or humidity changes rapidly. This may cause the image to temporarily
become hazy. If this occurs, turn the camera off and allow the camera to sit so
that the camera temperature can stabilise to the room's ambient temperature. The
required time will vary and can take up to an hour. It will clear by itself.
●
If you know that you will be moving between areas where there will be a large change
in temperature or humidity, you can help prevent condensation forming on the camera
by placing the camera in a large plastic zipper bag, so condensation will form on the
bag, not the camera. Allow the temperature to stabilise before removing the camera
from the bag.

Preparations

Preparations
7
SQT1120 (ENG)