JUNO JKSI808R5 User Manual page 8

8
Heat setting
3 - 4
5
6 - 9
The heat setting
To set or change the heat setting:
Touch the control bar at the correct heat
setting or move your finger along the
control bar until you reach the correct heat
setting.
Bridge function
This function connects two left side cooking
zones and they operate as one.
First set the heat setting for one of the left
side cooking zones.
To activate the function: touch
or change the heat setting touch one of the
control sensors.
To deactivate the function: touch
The cooking zones operate independently.
Automatic Heat Up
If you activate this function you can get a
necessary heat setting in a shorter time.
The function sets the highest heat setting
for some time and then decreases to the
correct heat setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch (
touch the correct heat setting. After 3
seconds comes on.
The hob deacti-
vates after
5 hours
4 hours
1.5 hour
. To set
comes on). Immediately
To deactivate the function: change the
heat setting.
Power function
This function makes more power available
to the induction cooking zones. The
function can be activated for the induction
cooking zone only for a limited period of
time. After this time the induction cooking
zone automatically sets back to the highest
heat setting.
Refer to "Technical information"
chapter.
To activate the function for a cooking
zone: touch
To deactivate the function: change the
heat setting.
Timer
Count Down Timer
You can use this function to set how long
the cooking zone should operate for a
single cooking session.
First set the cooking zone then set the
function. You can set the heat setting
before or after you set the function.
To set the cooking zone: touch
and again until the indicator of a necessary
cooking zone comes on.
To activate the function or change the
.
time: touch
time (00 - 99 minutes). When the indicator
of the cooking zone starts to flash slowly
the time counts down.
To see the remaining time: set the
cooking zone with
cooking zone starts to flash quickly. The
display shows the remaining time.
To deactivate the function: set the
cooking zone with
remaining time counts back to 00. The
indicator of the cooking zone goes out.
. comes on.
or of the timer to set the
. The indicator of the
and touch
again
. The