Table of Contents
Advertisement
HOW TO
•
The handle of joint ring is pressed to pull out the drain hose.
Change the direction of the drain hose and follow the above
guideline again.
CAUTIONS WHEN INSERTING THE DRAIN HOSE
1. Don't exceed more than 3 m when the
drain hose is used by connecting with
other hoses.
3. The doorsill shoudn't be more than 5cm.
Test run
Make sure that you install your washing machine correctly by running the Rinse+Spin cycle
after the installation is complete.
CALIBRATION MODE (OPTION)
Your Samsung washing machine detects the laundry weight automatically.
For more accurate weight detection, please run Calibration Mode after the installation.
To run Calibration Mode, follow these steps:
1. Remove laundry or any contents in the machine.
2. Press the Delay End and Spin buttons simultaneously, and then press the Power button. The Machine
turns on with "Cb"
3. Press the Start/Pause button to activate "Calibration Mode".
4. The drum rotates for approximately 4 minutes.
5. When "Calibration Mode" is fi nished, "End" appears on the display, and the machine automatically
turns off. The washing machine is now ready for use.
F700_WA18F7-03271G-04_EN (Australia).indd Sec6:19
F700_WA18F7-03271G-04_EN (Australia).indd Sec6:19
CHANGE THE DRAIN HOSE DIRECTION
Less than 3 m
Less than 3 m
Less than 5 cm
2. Be careful to drain water out at the end of
the drain hose.
4. Don't install the drain hose underneath the
wash machine.
installation & maintenance_19
2016-01-22
2016-01-22
2:51:03
2:51:03
Advertisement
Table of Contents
