Table of Contents
Advertisement
Instruction manual
Important safeguards
• The instruction manual contains important
operating and maintenance instructions. For
your safety, it is necessary to refer to the
manual. Keep the manual for future use.
• Do not hit or drop the unit
• Do not expose the unit to vibration, direct
sunlight, too high or low temperatures or
humidity.
• Do not disassemble the unit yourselves
Refer servicing to qualified service personnel
All the illustrations in this manual are
schematic images, which may differ from
actual objects.
Power supply
Battery operation
• This unit uses two 3V AAA batteries.
Your set will not work normally from the
battery supply, but there is the advantage that,
in case of a mains current failure or power
outage, your clock will continue to work. The
clock display will not light up, the clock time
and alarm setting will be held in the clock
memory by the battery back-up system.
This enables you to move the set from place
to place without re-setting the clock every time.
The battery back-up system is only meant to
be used for short-term power failures. For
longer durations the battery may become
exhausted or there may be some deviation in
accuracy.
AС operation
• The appliance is for household use only.
• Before the first connecting of the appliance
check that the voltage indicated on the rating
label corresponds to the mains voltage in your
location.
• Insert the plug into the electrical outlet.
• The set is now working as an electronic
clock.
3
General operations
Backlight brightness
• By default, the LED display backlight is set
to the medium level. Press the DIMMER
button to choose the high or low
backlight, or switch the display off.
Setting the clock
• In clock mode press the TIME button.
Choose 24h or 12h display mode by pressing the
12/24H button.
• Press the TIME button. Hour digits will flash.
Press the HOUR button to adjust the hour setting.
• Press the TIME button. Minute digits will flash.
Press the MIN button to adjust the minute setting.
• Once time is set correctly, press the TIME
button again to confirm.
Setting the alarm
• In clock mode press short press AL1 to check
the alarm, press and hold AL1 to set the alarm.
Short press HOUR to set hours, MIN to set
minutes, then press AL1 to confirm. The AL1
indicator will light up.
• During the alarm setting press the AL MODE
button to choose alarm mode: BB/buzzer or
FM.
• Press AL OFF to temporarily turn off the alarm
when it goes off. The alarm will ring at the same
time on the next day.
• The alarm rings for 30 minutes and stops if no
buttons are pressed. The alarm will ring at the
same time on the next day.
• To disable the alarm press the AL1 button and
then the AL OFF button. The AL1 indicator
starts to flash. Press the AL1 and AL OFF
buttons again to confirm. The AL1 indicator will
disappear, meaning the alarm is disabled.
• If you choose radio as the alarm signal, and the
unit already plays radio as the alarm goes off, it
will only appear on the display.
• AL2 settings are the same as AL1.
Advertisement
Table of Contents
