Advertisement

Quick Links

User Manual
Bluetooth GPS Receiver
BT-309
Ver 1.0

Advertisement

Table of Contents
loading

Summary of Contents for Dell BT-309

  • Page 1 User Manual Bluetooth GPS Receiver BT-309 Ver 1.0...
  • Page 2 BT-309 at a glance...
  • Page 4: Power Switch

    1. Introduction The BT-309 is a GPS receiver with Bluetooth interface and built- in active antenna for high sensitivity to tracking signal. Based on the SiRF star Ⅱe/LP low power chip set and supports all functions(SingleSat updates in reduced visibility, Superior urban canyon performance, FoliageLock for weak signal tracking, etc.).
  • Page 5: Led Function

    The only condition that you need external antenna is when BT-309 unit can not “see” the sky, For instance, when you are in any environments that GPS signal is blocked, the external GPS antenna will help to receive better GPS signal.
  • Page 6 ? 1. Switch the BT-309 power on. 2. Please refer to the user manual of Bluetooth device to enable it connecting to the BT-309. Some Bluetooth devices may need the Bluetooth passkey, the passkey is “2003”. 3. Check the number of COM port used by Bluetooth.(Example COM 6).
  • Page 7 3. How to test your Bluetooth GPS Receiver ? The testing program only supports the Microsoft Windows CE & Pocket PC based PDA platform. 1. Run the “GPSinfo.exe” to execute the installation procedure of testing program (via PC and ActiveSync). 2.
  • Page 8: System Specification

    3. System Specification Electrical Characteristics (Receiver) Frequency L1, 1575.42 MHz C/A Code 1.023 MHz chip rate Channels Sensitivity -170 dBW Accuracy Position Horizontal 15m 2D RMS (SA off) WAAS enabled 10m 2D RMS (SA off) Time 1 micro-second synchronized to GPS time Velocity 0.1m/sec 95% (SA off) Datum...
  • Page 9: Bluetooth Specification

    External antenna Power 3.3V Connector MMCX Power Voltage Built-in rechargeable battery(900 mAh) and 5V DC input charging circuit Operation Time 8 hr. After fully recharged, in continuous mode >10 hr in trickle power mode Physical Characteristics Dimension 85mm x 47mm x 26mm Weight Temperature Operating...
  • Page 10: Fcc Notices

    FCC Notices This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2)This device must accept any interference received, including interference that may cause undesired operation . FCC RF Exposure requirements: This device and its antenna(s) must not be co- located or operation in conjunction with any other antenna or transmitter.

Table of Contents