en Troubleshooting
Fault
"E:30/-20"
The appliance is not
working.
The programme does
not start.
The door cannot
be opened.
38
Cause and troubleshooting
▶
Do not add any extra water to the appliance while it
is operating.
The mains plug of the power cord is not plugged in.
▶
Connect the appliance to the power supply.
The circuit breaker in the fuse box has tripped.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other
appliances are working.
You have not pressed Start / Reload.
▶
Press Start / Reload.
Door is not closed.
Close the door.
1.
Press Start / Reload to start the programme.
2.
Childproof lock is activated.
→ "Deactivating the childproof lock", Page 31
▶
Finish in is activated.
Check whether Finish in is activated.
▶
→ "Buttons", Page 22
Laundry is caught in the door.
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press Start / Reload to start the programme.
4.
– –– is activated.
Continue the programme by selecting Spin or
▶
Drain and pressing Start / Reload.
→ "Resuming the programme when the programme
status is Rinse Hold", Page 30
The temperature is too high.
▶
Wait until the temperature has dropped.
→ "Cancelling the programme", Page 30
▶
Water level is too high.
▶
Select a suitable programme for draining.
→ "Programmes", Page 23
Power failure.
▶
Open the door using the emergency release.
→ "Emergency release", Page 44