LG F4J5VN Series Owner's Manual page 40

Hide thumbs Also See for F4J5VN Series:
Table of Contents

Advertisement

Symptoms
Door does not open
Wash cycle time
delayed
Fabric softener
overflow
Softeners
dispensed too early
Dry problem
Odor
Reason
Once washing machine has
started, the door cannot be
opened for safety reasons.
If an imbalance is detected or if
the suds removing programme
is on, the wash time will
increase.
Too much softener may cause
an overflow.
Too much softener may cause
an premature dispensing.
Check water supply tap.
This odor is caused by the
rubber attached to the washing
machine.
If the rubber door gasket and
door seal area are not cleaned
regularly, odors can occur from
mold or foreign substances.
Odors can occur if foreign
substances are left in the
drainage pump filter.
Odors can occur if the
drainage hose is not properly
installed, causing siphoning
(water flowing back inside the
washing machine).
Using the dry function, odors
can occur from lint and other
laundry matter sticking to the
heater.(Dryer model only)
A particular odor can occur
from drying wet clothes with
hot air. (Dryer model only)
Solution
• Check if the 'Door Lock' icon is
illuminated. You can safely open the
door after the 'Door Lock' icon turns off.
• This is normal. The time remaining
shown in the display is only an
estimate. Actual time may vary.
• Follow softener guidelines to ensure
appropriate amount is used. Do not
exceed the maximum fill line.
• Follow the guidelines provided by the
detergent manufacturer.
• Close the dispenser drawer slowly. Do
not open the drawer during the wash
cycle.
• Do not overload. Check that the
washing machine is draining properly to
extract adequate water from the load.
Clothes load is too small to tumble
properly. Add a few towels.
• Turn off water supply tap.
• It is the normal odor of new rubber and
will disappear after the machine has
been run a few times.
• Be sure to clean the gasket and door
seal regularly and check under the door
seal for small items when unloading the
washer.
• Be sure to clean the drainage pump
filter regularly.
• When installing the drainage hose, be
sure that it doesn't become kinked or
blocked.
• This is not a malfunction.
• The odor will disappear after a short
while.
EN
39

Advertisement

Table of Contents
loading

Table of Contents