Playard/Crib - Century Fold 'n Go® ElanTM Deluxe Bassinet 10747 Instruction Manual

Playard/Crib

1
To remove floorboard:
• Unfasten attachment straps.
• Remove floorboard and set
aside.
2
To unlock and raise floor:
• Push down on center of
Playard/Crib floor.
• Lift Floor Handle and rotate
in direction of arrow
(counterclockwise).
• Pull up on Floor Handle to
raise floor.
Raise approximately
45.7 cm
(18 inches).
Floor
Handle
3
To fold top rails:
• Pull up on top rail slightly.
• Squeeze Release Button
on bottom of top rail and
push rail down. (Release
buttons are identified by
printed arrows.)
Repeat for other sides.
NOTE:
• If rails are difficult to
unlock, raise center of
floor higher and
squeeze Release
Button again.
• If only one side of rail
folds, squeeze Release
Button again to fully
fold.
FOLDING and STORING continued
Release
Button
4
Gather Playard/Crib frame together
while pulling up on Floor Loop.
5
Wrap floorboard around
Playard/Crib frame with
padding facing in.
NOTE: Floorboard Handle MUST
be aligned with wheels as shown.
6
Secure Attachment Straps:
• Bottom - Thread Attachment
Strap through Leg Loop then
through Floorboard Loop
and fold back onto itself.
• Middle and Top - Thread
Attachment Straps
through remaining
floorboard loops
and fold back onto
themselves.
Floorboard Loop
7
Position travel bag over
Playard/Crib so Handle comes
through Opening in side of bag.
Pull travel bag over Playard/Crib.
Pull Floor Loop through
opening on top of travel bag.
NOTE: To prevent rubbing,
make sure travel bag is
positioned above wheels.
Floor Loop
Handle
Attachment
Straps
Leg Loop
Floor Loop
Opening
Handle
8