How To Use The Steamer - Panasonic EH-SA31VP Operating Instructions Manual

Preparation
1
1
Place the main unit on a flat, level surface.
● Place the appliance on a flat, level and solid surface, such as a desk, etc.,
when using. Do not hold the appliance in your hands during use.
● If the appliance is not standing straight, the water supply tank cannot supply
water to the main unit, and the main unit will not be able to release steam.
2
2
Remove the water supply tank from the main unit.
● Pull up on the water supply tank.
3
3
Turn and open the water supply cap.
4
4
Fill the water supply tank with water and close the
water supply cap.
● The steam lasts for about 6 minutes when the water is filled
to "FULL" mark and for about 3 minutes when the water is
filled to "HALF" mark.
5
5
Wipe away any water on the surface of the water
supply tank.
6
6
Attach the water supply tank to the main unit.
● Push the water supply tank into the main unit until it clicks.
● Water is supplied to the main unit and the water in the tank
decreases when the water supply tank is attached the main unit.
● If the water supply tank is repeatedly attached and removed,
water may begin to leak from the water outlet. It is normal.
Use only distilled water or purified water.
Since the service life of the appliance may shorten depending on water quality,
the use of distilled water or purified water is recommended. Please purchase
them separately.
8
8-9
The following types of water cannot be used due to its high mineral content.
● Tap water
● Mineral water
● Geothermal water
● Acidulated water
● Groundwater
● Ionized Alkaline water
Caution:
Do not mix with anything.
Do not mix the water with any other substance, such as lotion, aromatic oil, etc.
Doing so may cause burns, malfunctions, or shorten the life of the main unit.

How to use the steamer

1
1
Insert the appliance plug into the main unit.
2
2
Plug in the plug into the power outlet.
3
3
Slide the power switch upwards to turn on the
appliance.
The steam is released after about 1 minute.
● A whizzing may be heard. This is the sound of electric
discharge which is normal.
● A little hot water may be sprayed out when the main
unit starts emitting steam. This is not a malfunction.
4
4
Direct the steam to your face.
● Keep your face at least 20 cm (8") away from
the nozzle.
● When using the appliance for the first time, or if
it is difficult to judge the distance, use the
attached "Distance Guide" to determine the
correct distance between the nozzle and the
area to be exposed to steam.
● To ensure that the steam covers your entire
face, direct the steam to the top of your chin.
The steam stops after about 6 minutes when the water is filled to "FULL"
mark and after about 3 minutes when the water is filled to "HALF" mark.
(The duration of steam changes with the amount of water that is filled)
● When the remaining water is low, the way that the steam is emitted
changes. This is not a malfunction.
● If there is no water in the water supply tank, no steam will emit from the
steam outlet. Please turn off the appliance and add water after allowing the
appliance to cool down for at least 10 minutes.
9
2013/11/06 16:44:04