Uniform Industrial UIC1000 Installation Manual

UIC1000 Installation Manual
SPEC
Item
CPU
Memory
Display
Size
Weight
Power
Power consumption
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/ TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the grantee of this
device could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Description
ARM7 AT91SO101B 32-bit ARM-SC100 RISC 50MHz
ARM9 AT91RM9200 ARM920T Processor 180MHz
Flash 16MB, SDRAM 16MB
Mono LCD with backlight
Pixel 128x64
L 135 mm x W 82 mm x H 25 mm
200g
DC 5 V / 500 mA
Max : 2.5 W
Idle : 1.25 W