Advertisement
November 2021© Kioti CS2520 ROPS Cab Operation Manual
4. Rear Work Light Rocker Switch (optional)
Low position: Off
High position: On
Note: indicator light activates when work light is on.
5. Washer Momentary Switch (Front and Rear optional)
Low position: On
Mid position: Off
High Position: On
6. Beacon Rocker Switch (optional)
Low position: Off
High position: On
Note: indicator light activates when work lights are on.
7. Water Heater Fan Rocker Switch (optional)
Low position: Off
High position: On
Note: indicator light activates when work lights are on.
Standard and optional features are individually fused, and the fuses can be accessed behind the
plug in the middle of the switch-plate.
Cab Circuit Protection
The Tektite ROPS cab is wired to provide maximum protection against individual circuit
overload. All optional components are fused internally behind the cab switch plate.
After your ROPS Cab has been installed:
Before starting a tractor equipped with a Tektite ROPS cab:
1. Clear the operator platform of all tools. Tools left in or around the ROPS and tractor can
cause operator interference which could lead to bodily injury and/or damage the machine.
2. Inspect the ROPS and tractor to ensure all bolts are tight and re-tighten if required.
3. Ensure that all pedals, levers, and controls have adequate clearance for normal operation.
4. Ensure that all electrical components of both the ROPS and tractor operate normally.
5. Ensure your door latches properly onto the striker pin. Immediately after installation, the
ROPS frame may flex slightly from installation, and the door latch will need to be re-aligned for
Advertisement
