Download Print this page

Philips CT0298RED/40 Manual page 6

Philips mobile phone ct0298red 298

Advertisement

6.
Replace the cover by sliding down into its slots
until it stops.
"
Press and hold
until the power-on/off animation
is shown on the screen.
When switch on the phone, the phone may remind
you
to enter the PIN code. The PIN code is
predefined and supplied by your operator or retailer.
To personalize the PIN code, see "Change Pwd.".
If you enter an incorrect PIN code for three times,
your SIM card is blocked. To unblock it, you must
request the PUK code from your operator.
#
Your phone is powered by a rechargeable battery. A
new battery is partially charged and an alarm will
warn you when the battery level is low. If the
battery is empty, the battery symbol indicators will
reappear after the battery is charged up for 2 or 3
minutes.
1.
Plug the port of the USB cable to the socket at
the mother-base of the charger(supplied with
the phone, in the box) .
2.
Once the battery and back cover are attached
to the phone, plug the charger to the connector
into the socket at the base of the phone on one
end. Check that the arrow on the connector is
facing towards the phone. Then plug the other
end of the charger to an easily accessible AC
power socket.
To prevent damage of the phone,do not make a
telephone call or send SMS while the battery is
charging!
3.
The battery symbol indicates the state of
charge.

Advertisement

loading