Advertisement
6. OPERATION
6.1.
SET UP
Select your cleaning solution and fill 2/3rds of the tank. DO NOT exceed the filling line. Be aware of the displacement volume of the
6.1.1.
objects being treated to avoid overspill.
▲
DANGER! DO NOT use alcohol, gasoline or flammable solutions. Doing so could cause a fire or explosion. Use only water-based
solvents.
6.1.2.
Place the items into the basket, Slowly lower the basket into tank. DO NOT allow items to contact the tank bottom and always use the
basket to immerse items. The solution should cover the items - see section 6.1.1.
6.1.3.
A: Plug the cleaner into (earthed) mains supply.
B: Turn mains supply on and turn on the power switch on rear side of the machine.
NOTE:
After turning power on, initially the temperature you see on the display is the ambient temperature. Timing and temperature settings
default to those last used after 3 seconds.
6.2.
TIMER
6.2.1.
Press
NOTE:
Devices with memory function will remember your last setting.
6.3.
HEATING
6.3.1.
Press
to start/stop heating. Press
6.3.2.
To get the best cleaning result, the solution's temperature should be 40° to 60°C. Warm water and dish washing liquid can soften
grease and improve cleaning results.
6.3.3.
When setting the temperature, if you want the temperature of the bath to be higher than the ambient temperature, press
'Heating' button. The heating will come on. If your required temperature is below the ambient temperature, the heating will not come
on. The light above the thermostat button will not illuminate.
6.3.4.
Heating does shut off automatically, if timer is used, when it reaches zero.
6.3.5.
The device's memory function will remember the last setting.
6.4.
DEGAS MODE
6.4.1.
After setting the timer and temperature, press
working for 6 seconds, and stopping for 2 seconds, then working for 6 seconds. It will cycle like this with the display counting down.
6.4.2.
Intermittent operation of ultrasonic power will degas the cleaning liquid.
6.4.3.
If you want to transfer to another mode, press
button light for 'normal' or 'soft' turn on; to stop it working, press
the corresponding indicator turn off.
6.5.
NORMAL MODE
6.5.1.
After timer and temperature setting, press
'normal mode': continuously working with full ultrasonic power and countdown display.
6.5.2.
To switch to other modes, press
ultrasonic mode will stop and the corresponding button light will turn off.
6.6.
SOFT MODE
6.6.1.
Set the timer and temperature, press
to another mode, press
turn on; To stop working, press
off.
NOTE:
Degas, Normal and Soft cannot be operated simultaneously.
© Jack Sealey Limited
Control Panel
to set the cleaning time. The timer will count down to 00:00, the tank will switch off.
'Normal' button, the corresponding button light will turn on and the device will work in
'Degas' or
, 'soft mode', the button light will turn on and the device will work in soft mode. To transfer
'Degas' or
'normal', the 'soft mode' light will turn off and indicator light of 'degas' or 'normal' will
'soft' again, then both heating and ultrasonic will stop and the corresponding button light will turn
Original Language Version
to set the temperature.
, the light above this button will come on. The device will now be in degas mode:
'normal' or
'soft'. Then the 'degas' indicator will turn off and indicator
'Degas' again, then both heating and ultrasonic will stop and
'soft'. To stop, press
'normal' again, then both the heating and
SCT03, SCT09, SCT27 Issue1 25/09/20
Advertisement
