Table of Contents
Advertisement
Fault
The programme does
not start.
The door cannot
be opened.
The water is not drain-
ing.
Cause and troubleshooting
→ "Deactivating the childproof lock", Page 35
▶
Finish in is activated.
Check whether Finish in is activated.
▶
→ "Buttons", Page 22
Laundry is caught in the door.
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press Start / Pause to start the programme.
4.
– –– is activated.
Continue the programme by selecting Spin or
▶
Drain and pressing Start / Pause.
→ "Resuming the programme when the programme
status is Rinse Hold", Page 34
The temperature is too high.
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 34
▶
Water level is too high.
Start the Drain programme.
▶
Power failure.
Open the door using the emergency release.
▶
→ "Emergency release", Page 51
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
Drain pump is blocked.
→ "Cleaning the drain pump", Page 39
▶
– –– is activated.
Continue the programme by selecting Spin or
▶
Drain and pressing Start / Pause.
→ "Resuming the programme when the programme
status is Rinse Hold", Page 34
The water outlet hose is connected too high.
Install the water outlet hose at a maximum height of
▶
1 metre.
Detergent dosage is too high.
Troubleshooting en
45
Advertisement
Table of Contents
