Advertisement
At power On/Off, the selected tone will not be changed.
CTCSS TONE NUMBER & FREQUENCY
No.
Freq.(Hz)
No.
Freq.(Hz)
1
67
11
2
71.9
12
3
74.4
13
103.5
4
77
14
107.2
5
79.7
15
110.9
6
82.5
16
114.8
7
85.4
17
118.8
8
88.5
18
9
91.5
19
127.3
10
94.8
20
131.8
VOLUME CONTROL
Press the UP/DOWN key to increase(to decrease) the volume level from 1 to 32(from 32 to 1)
!
Press the UP/DOWN key to return to Repeat Mode for more than (0.2) seconds.
!
When power On/Off, the volume level will be not changed.
!
The volume level will be changed to original level during replacing a battery.
MONITOR KEY
1.
Monitor On/Off
2.
Continuous Monitor Mode On/Off
!
Normal Monitor Mode
During pressing the Monitor key, Audio is On and RX Icon appears on the LCD.
Release the key to return to Stand-by Mode and Audio will be muted
!
Continuous Monitor Mode
Press the Monitor key for more than (3) seconds, Monitor Mode will be operated with
Single Beep (RX Icon appears on the LCD)
BACK LIGHT ON/OFF
When any key is pressed, the LCD will be illuminated.
The lamp will be out after (5) seconds.
BATTERY SAVER
After (4) seconds elapse with no key entries, no call received, and no transmission, Battery Saver
automatically functions. It repeats switching ON and OFF the power to the receiver at certain ratios to
maximize battery life. You cannot switch OFF this function.
SPECIFICATIONS
Frequency range
Supply voltage (rated voltage)
Transmit output power
Dimensions (W x H D, projection not included)
Weight (with 4 AAA batteries)
No.
Freq.(Hz)
No.
97.4
21
136.5
31
100
22
141.3
32
23
146.2
33
24
151.4
34
25
156.7
35
26
162.2
36
27
167.9
37
123
28
173.8
38
29
179.9
30
186.2
462.5625 – 467.125 MHz (14 Channels)
6.0 V
500mW
00.0 X 000.0 x 00.0 mm
(0.00 x 0.00 x 0.00 inches)
Approx. 000g (0.0 oz.)
Freq.(Hz)
192.8
203.5
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
210.7
conditions:
218.1
(1) this device may not cause harmful interference, and (2) this device must accept any interference
225.7
received, including interference that may cause undesired operation.
233.6
One or more of the following statements may be applicable:
241.8
250.3
FCC WARNING
This equipment generates or uses radio frequency energy. Changes or modifications to this
equipment may cause harmful interference unless the modifications are expressly approved in the
instruction manual. The user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE FCC
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can generate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that the interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer for technical assistance.
SAFETY INFORMATION
Your wireless hand-held portable transceiver contains a low power transmitter. When the Push-to-
Talk (PTT) button is pushed it sends out radio frequency (RF) signals. The device is authorized to
operate at a duty factor not to exceed 50%. In August 1996, the Federal Communications
Commissions (FCC) adopted RF exposure guidelines with safety levels for hand-held
wireless devices.
CAUTION: To maintain compliance with the FCC's RF exposure guidelines hold the transmitter and
antenna at least 2 inch (5 centimeters) from your face and speak in a normal voice, with the antenna
pointed up and away from the face. If you wear the handset on your body while using the headset
accessory, use only the Kenwood supplied belt clip for this product and when transmitting, take it out
of the belt to ensure that the antenna is at least 1 inch (2.5 centimeters) from your body.
Use only the supplied antenna. Unauthorized antennas, modifications, or attachments could damage
the transmitter and may violate FCC regulations.
NOTICES TO USER
Advertisement
