Basic Operations; Basic Operation Procedures; Power On; Selecting The Image To Be Projected - JVC D-ILA DLA-HX2U Instructions Manual

Basic Operations

If projector set up is not yet complete, please read 'Adjustments and Settings Using Menus' on page 32 and perform the necessary
settings.
LAMP TEMP
PC VIDEO
V-KEYSTONE H-KEYSTONE
MENU
ENTER
PC VIDEO
W
V-KEYSTONE H-KEYSTONE SCREEN
S
VOLUME FOCUS
QUICK ALIGN.
MENU
ENTER
PRESET
Note
• Messages are displayed in the language set
by the user in the "Language" menu. The pre-
set language upon purchase is "English". The
user can choose from 8 national languages.
(☞ page 39)
However, the input mode ([PC1], [PC2],
[PC3], [Y/C], [VIDEO]) and button indications
([FREEZE], [D.ZOOM], [EXIT]) are only dis-
played in English irrespective of the display
language setting.
STAND BY
OPERATE
1-
2
2
VOL.
EXIT
1-
2
OPERATE
2
DIGITAL
ZOOM
FREEZE
EXIT
HIDE

Basic Operation Procedures

Once the basic settings are done, follow the procedures below:
1.

Power On

1
Insert the power cord into the wall outlet
• The [STAND BY] indicator lights up when the main power is
inputted.
2
Press the [OPERATE] button on the projector (or the [OP-
ERATE] button on the remote control unit) for one second
or more
• The [OPERATE] indicator lights up and the projected image
slowly appears.
OPERATE
OPERATE
Projector:
Control panel
Notes
• Upon projection, the image may flicker for a few seconds, but
this is not a malfunction.
• When the lamp is turned on, it will slowly become brighter. It
will take more than a minute for the brightness to stabilize.
2.

Selecting the image to be projected

Press [VIDEO] to select which of the image devices of those
connected to the [VIDEO IN] ([VIDEO] or [Y/C]) terminals is
output
VIDEO
Projector:
Control panel
• Each time you press either button, the selected input changes
as follows.
[Y/C]
[VIDEO]
Notes
• Sound is formed from sound signals connected to the [AU-
DIO IN] terminal.
• When no image is input to the selected input terminal, the
message "No Input" is displayed on the screen. (☞ page 53)
LAMP
Projector: Indicator
LAMP
Remote
Projector: Indicator
control unit
VIDEO
Remote
control unit
[VIDEO] : Image from the input [VIDEO]
terminal on the right hand side
of projector will be projected.
[Y/C] : Image from the input [Y/C] ter-
minal on the right hand side of
the projector will be projected.
Light on
STAND BY
TEMP OPERATE
Light on
STAND BY
TEMP OPERATE
25