LG F4J6TM0W Owner's Manual page 42

Symptoms
Water does not
enter washing
machine or it enters
slowly
Water in the
washing machine
does not drain or
drains slowly
Washing machine
does not start
Washing machine
will not spin
Door does not open
Wash cycle time
delayed
Fabric softener
overflow
42
Reason
Water supply is not adequate in
that location.
Water supply tap is not
completely open.
Water supply hose(s) are
kinked.
The filter of the supply hose(s)
clogged.
Drain hose is kinked or
clogged.
The drain filter is clogged.
Electrical power cord may not
be plugged in or connection
may be loose.
House fuse blown, circuit
breaker tripped,or a power
outage has occurred.
Water supply tap is not turned
on.
Check that the door is firmly
shut.
Once washing machine has
started, the door cannot be
opened for safety reasons.
If an imbalance is detected or if
the suds removing programme
is on, the wash time will
increase.
Too much softener may cause
an overflow.
Solution
• Check another tap in the house.
• Fully open tap.
• Straighten hose.
• Check the filter of the supply hose.
• Clean and straighten the drain hose.
• Clean the drain filter.
• Make sure plug fits tightly in wall outlet.
• Reset circuit breaker or replace fuse.
Do not increase fuse capacity. If
problem is a circuit overload, have it
corrected by a qualified electrician.
• Turn on water supply tap.
• Close the door and press the Start/
Pause button. After pressing the
Start/Pause button, it may take a few
moments before the washing machine
begins to spin. The door must be
locked before spin can be achieved.
Add 1 or 2 similar items to help balance
the load. Rearrange load to allow
proper spinning.
• Check if the 'Door Lock' icon is
illuminated. You can safely open the
door after the 'Door Lock' icon turns off.
• This is normal. The time remaining
shown in the display is only an
estimate. Actual time may vary.
• Follow softener guidelines to ensure
appropriate amount is used. Do not
exceed the maximum fill line.
EN