Set Up Procedures - Takahashi FOA60-K Instruction Manual

◆ Attaching the Finder Bracket
Place the finder bracket leg on the finder
base on the main tube and lock it firmly
with two cap-bolts, using 4mm hex wrench
provided. Set the finder scope so that it is as
parallel to the main tube as possible. Failure
to do so can make alignment difficult.
Hex Wrench
(4mm)
Finder Bracket
Finder Base
Hex Wrench (6mm)
Tube Holder
Tube Holder Base
Equatorial Mount

Set Up Procedures

Cap Bolt
Washer
Focuser Unit
Cap Bolt
Tube Holder
Clamp
◆ Attaching the Finder Scope
As illustrated at the bottom, insert the
finder into the bracket so that the finder lock
screw presses into the finder scope at the
groove. Set the finder scope in the center
of the bracket and lock it with the adjusting
screws and lock screws. Attach the finder
to a position as parallel to the main tube as
possible.
6x30 Finder Scope
Groove
◆ Setting the Telescope on the Mount
Set the tube holder on the tube holder base
with two cap-bolts, and then place the tube
assembly on the tube holder and lock the
tube holder with the clamp after balancing
the tube assembly. The tube holder can be
used with all Takahashi mounts. If using this
equipment for astro-imaging, the heavier
duty the mount, the better.
- 7 -
Finder Adjusting Screw
Lock Nut
Lock Screw
Finder Bracket