Table of Contents
Advertisement
DOOR HOW TO OPEN IT IN CASE OF A FAILURE, TO TAKE OUT
YOUR LAUNDRY
Switch o the washing machine and unplug it. Close the water tap.
Wait until the drum has stopped rotating. Never open the door while the drum is in motion.
Wait until water and laundry have cooled down when washing with high temperatures.
Always drain the water before opening the door.
Before opening the door as described in below section, refer
to failure "Door is locked with or without failure indication,
and the programme does not run". The door may unlock by
itself after conditions like for example a power breakdown do
not persist anymore.
Only if the door cannot be opened as described in the section
mentioned before, proceed as described below. In case of a
power breakdown, the washing machine will proceed where
it was interrupted as soon as power is available again. If a
failure occurs on the washing machine and the door is locked,
but you must take out your laundry:
1.
First drain the residual water, as described in section
"CLEANING & MAINTENANCE/ Draining residual water".
2.
Remove the screw with a screwdriver.
TRANSPORT AND HANDLING
Never lift the washing machine by holding it at the worktop.
1.
Pull out the mains plug, and close the water tap.
2.
Make sure that door and detergent dispenser are properly
closed.
3.
Disconnect the inlet hose from the water tap, and remove
the drain hose from your draining point. Remove all rest
water from the hoses, and x them so that they cannot
get damaged during transport.
16
3.
Then pull downwards the strap as indicated in the
following gure. You can now open the door and take out
your laundry.
4.
Afterwards x the strap again by rmly turning in the
screw with the screwdriver.
5.
Reinstall the plinth.
4.
Re t the transport bolts. Follow the instructions for
removing the transport bolts in the "Installation Guide" in
reverse order.
Important: Do not transport the washing machine without
having xed the transport bolts.
User manual
Advertisement
Table of Contents
