Table of Contents
Related Manuals for Jet JAT-650
Summary of Contents for Jet JAT-650
- Page 1 Pneumatic Screwdriver #505650, JAT-650 #505651, JAT-651 After s/n 15050201 Operation & Parts Manual M-505650 Edition 5 10/2021 427 New Sanford Road LaVergne, TN 37086 Ph.: 800-274-6848 www.jettools.com Copyright © 2017 JET...
-
Page 2: Warranty And Service
Shop Tools; Warehouse & Dock products; Hand Tools; Air Tools NOTE: JET is a division of JPW Industries, Inc. References in this document to JET also apply to JPW Industries, Inc., or any of its successors in interest to the JET brand. -
Page 3: Safety Warnings
15. Excessive air pressure and too much free Do not use this tool for other than its intended rotation may decrease life of the tool and may use. If used for other purposes, JET disclaims cause a hazardous situation. any real or implied warranty and holds itself 16. - Page 4 32. Do not lubricate the tool with combustible specifically designed to filter out microscopic liquids, such as kerosene, diesel or jet fuel. particles. more information http://www.p65warnings.ca.gov/ http:// 33.
-
Page 5: About This Manual
As with any tool operation, safety of operator and bystanders should be first priority. If there are questions or comments, please contact your local supplier or JET. JET can also be reached at our web site: www.jettools.com. -
Page 6: Tool Specifications
Specifications were current at time of publication, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations. -
Page 7: Setup And Assembly
Any missing parts or damage should be reported Use selector switch for rotation direction ® immediately to your JET distributor. Do not use a (F/R). damaged tool. Read this instruction manual thoroughly for operation, maintenance and safety Gently press trigger. - Page 8 Lubrication Information Use a light oil containing rust inhibitors, such as SAE #10. Many JET air tools have integral oil If the air tool is not performing according to reservoirs, which should be kept filled when in-line specifications, the following are among the most common causes.
- Page 9 Figure 2 Recommended arrangement of air piping and air line system...
- Page 10 Troubleshooting JAT-650/651 Screwdriver Any disassembly of the tool should be done by qualified service personnel. For problems not addressed below, contact JET technical service at 800-274-6846. Problem Possible cause Remedy Tool will not start. Air valve closed or obstructed. Open valve; clear any obstructions.
-
Page 11: Replacement Parts
Non-proprietary parts, such as fasteners, can be found at local hardware stores, or may be ordered from JET. Some parts are shown for reference only, and may not be available individually. - Page 12 #505650, JAT-650, 1/4-inch Screwdriver – exploded view JAT-650,651 Screwdrivers...
- Page 13 #505650, JAT-650, 1/4-inch Screwdriver – parts list Index Part No. Description Index Part No. Description JAT610-01 Motor housing 80230 Retaining ring JSM7572-02 Pin 2x18.8 JSM3330-49 O-Ring 26.7x1.78 JSM7572-03 Air inlet JSM7572-32 Reversing valve JSM7572-04 Trigger SB-1/8 Steel ball 1/8in. JSM7572-05...
- Page 14 #505651, JAT-651, 1/4-inch Screwdriver – exploded view JAT-650,651 Screwdrivers...
- Page 15 #505651, JAT-651, 1/4-inch Screwdriver – parts list Index Part No. Description Index Part No. Description JAT610-01 Motor housing JAT661-28 Clamp nut JSM7572-02 Pin 2x18.8 80429 Drive dog JSM7572-03 Air inlet 80230 Retaining ring JSM7572-04 Trigger JSM3330-49 O-Ring 26.7x1.78 JSM7572-05 Valve stem JSM7572-32 Reversing valve JSM7572-06...
- Page 16 427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.jettools.com JAT-650,651 Screwdrivers...