Connections - Telefunken D50F272N4CW Instruction Manual

Connections

Connector Type
VGA
Connection
(back)
PC/YPbPr
AUDIO IN
Audio
Connection
(back)
HDMI
Connection
(side&back)
SPDIF
SPDIF
(Optical Out)
Connection
(back)
Back AV
BACK AV
(Audio/Video)
Connection
(back)
HEADPHONE
Headphone
Connection
(side)
YPBPR YPbPr Video
Connection
(back)
USB
Connection
(side)
CI
Connection
(side)
LAN
Ethernet
Connection
(back)
If you want to connect a device to the TV, make sure that both the TV and the device are turned off before making
any connection. After the connection is done, you can turn on the units and use them.
Cables
YPbPr/PC Audio Cable
AV Cable
PC to YPbPr Connection Cable
LAN / Ethernet Cable
English - 42 -
Device
NOTE: When connecting a
device via the YPbPr or Back
AV inputs, you must use the
connection cables to enable
connection. See the illustrations
on the left side. | You can use
YPbPr to VGA cable to enable
YPbPr signal via VGA input. |
You cannot use VGA and YPbPr
at the same time. | To enable PC/
YPbPr audio, you will need to
use the back audio inputs with
a YPbPr/PC audio cable for
audio connection. | When using
the wall mounting kit (available
from a third party in the market,
if not supplied), we recommend
that you plug all your cables
into the back of the TV before
mounting on the wall. | Insert
or remove the CI module only
when the TV is SWITCHED OFF.
You should refer to the module
instruction manual for details of
the settings. | The/Each USB
input of your TV supports devices
up to 500mA. Connecting devices
that have current value above
500mA may damage your TV. |
By connecting an HDMI cable to
your TV, you have to use only a
shielded HDMI cable to guarantee
a sufficient immunity against
parasitic frequency radiation.