Advertisement
Assembly Instructions Page 3
6b
STEP 1
6d
STEP 3
6a: Attach Backpack Straps
6b: Lay the center webbing section of the Shoulder Pad section in a "loop" over bottom rear section of Foot
Platform
6c: Pull both ends of Shoulder Strap section both THROUGH the grating in Foot Platform
loop. Center straps evenly and then pull both straps to tighten STEP 2.
6
6d: Take the 2 webbing strips and on each front bottom side of Foot Platform
the grating STEP 3. Then feed each opposite, non-looped side of webbing strip through looped end, pull to
tighten STEP 4.
6e: Feed each end of the bottom webbing sections through the "ladder lock" at each end of the padded shoulder
strap section. Note the webbing first feeds through the TOP section of each ladder lock STEP 5. Finally,
weave each lower webbing end back through each BOTTOM section of ladder locks STEP 6 NOTE: Pull
straight down to tighten and secure straps. To loosen, pull upward on bottom of ladder lock tab.
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
Customer Service Department 1-866-972-6168
6a
STEP 4
to the Foot Platform
STEP 1.
MAKE SURE ALL BOLTS
ARE TIGHT BEFORE PRO-
CEEDING TO ATTACH TO
section of the assembled Treestand.
W A R N I N G
Model: PVLS-211
Blackjack Steel Hang-On Stand
6c
STEP 2
6e
STEP 5
STEP 6
and the webbing
, feed the looped ends through
www.primaltreestands.com
©2020 (rev. 1/20)
Advertisement
