AEG SFE81821DS User Manual page 30

30 www.aeg.com
Problem
A symbol or
shown instead of numbers
on the Temperature Display.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
The compressor does not
start immediately after
pressing the COOLMATIC,
or after changing the tem-
perature.
Water flows inside the refrig-
erator.
Water flows on the floor.
Possible cause
Temperature sensor prob-
symbol is
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FROSTMATIC is
switched on.
The COOLMATIC is
switched on.
This is normal, no error has
occurred.
This is normal, no error has
occurred.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
Solution
Contact the nearest Author-
ised Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation".
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "FROSTMATIC func-
tion".
Refer to "COOLMATIC func-
tion".
The compressor starts after a
period of time.
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.