Greencut JET-3800 Instruction Manual page 37

BOX CONTENTS
1. Pressure washer
2. Floor cleaning accessory
3. Brushes (2x)
4. Gutter Cleaner Accessory
5. Attachment for 360º spraying
6. Outlet nozzles (5x)
7. Pistol
8. Additional 20m hose
9. User's manual
• Carefully remove products and accessories from the box. Make sure all items are included.
• Inspect the product to make sure it has not been damaged or broken while being transported.
• Do not discard packaging materials until you have had the opportunity to carefully inspect the product and have
used it satisfactorily.
ATTENTION: If any part is missing or damaged, please contact the Official Technical Service. Do not
use this product without replacing the part. Using this product with damaged or missing parts can
cause serious injury to the operator.
IGNITED
1. Connect the water supply hose to the appliance and connect the gun to the outlet hose.
2. Connect the nozzle and nozzle extension.
3. Check that the filter is free of clogging.
4. Connect the water supply hose.
5. Check that the hose is not bent.
6. Turn on the water and check for leaks.
7. Push the trigger to release air from the pump and hose and then lock the trigger.
8. Plug the appliance in and turn the switch to the ON position.
9. Unlock the trigger and use the pressure washer.
ATTENTION: It is important to bleed the gun before using the pressure washer. Pull the trigger to
release any air trapped inside the appliance and hose. Continue to squeeze the trigger until a steady
stream emerges from the nozzle.
SWITCHING OFF
1. Stop the engine by moving the switch to the OFF position.
2. Unplug the device from the power supply.
3. Turn off the water supply.
4. Press the gun trigger to depressurize the system.
5. Disconnect the water supply hose from the pressure washer.
1
2
3
5
6
37
9
EN
4
8
7