Table of Contents
Advertisement
INSTALLATION STEPS
This quick start guide explains how to install the BDS Temperature Kiosk. Follow the steps listed next.
NOTE: Upon first use, the BDS unit may display inconsistent temperature readings until the unit boots up and the Infrared Sensors warm
up.
NOTE: The BDS supports two languages: English and Chinese. Adding custom language support may require APK and firmware updates
that could potentially take up to one month.
STEP 1. CONNECT THE GATE
Connect the tablet relay cable to the door open button terminal of the gate control board. If the door opening action is reversed, reverse
the line order.
Š If there is no response, set in the BDS (EZ-Pass) app as follows:
Š
Š Mode 0: Indicates non-automatic closing mode. The relay will not close automatically after opening the relay.
Š
Š Mode 1: Represents the auto-closing mode (active high-default low level, then high level for X seconds, last low level). The relay will
Š
automatically close after a delay of X seconds after opening the relay.
Š Mode 2: Represents the auto-closing mode (active low-default low, then high for X seconds, and finally low). The relay will automatically
Š
close after a delay of X seconds after opening the relay.
STEP 2: REVIEW THE PORTS DEFINITION
2.1 WIRE INTERFACE DEFINITION VERSION 1
12 VDC
TABLE 1. DELAY
PIN NUMBER
TERMINAL ELECTRICAL DEFINITION
1
COM
2
NO
USB OTG
Wiegand
Output
Wiegand
Input
1.877.877.2269
USB Host
UBOOT
Ethernet
Relay
FIGURE 1.
BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
RS-232
3
Advertisement
Table of Contents
