Tanita InnerScan UM-075 Manual

Tanita InnerScan UM-075 Manual

Body composition monitor

Advertisement

MANUAL
Model : UM-075
Instruction Manual
GB
Read this Instruction Manual carefully and keep it for future reference.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the InnerScan UM-075 and is the answer not in the manual?

Questions and answers

Summary of Contents for Tanita InnerScan UM-075

  • Page 1 MANUAL Model : UM-075 Instruction Manual Read this Instruction Manual carefully and keep it for future reference.
  • Page 2: Table Of Contents

    Table of Contents Introduction..............1 Features and Functions..........1 Preparations Before Use.......... 2 Getting Accurate Readings........2 Automatic shut-down function ........ 2 Switching the weight mode........2 Setting and storing personal data in memory ..... 3 Taking weight and body fat readings ....4 Programming the guest mode ........
  • Page 3: Introduction

    Tanita takes no responsibility for any kind of damage or loss caused by these units, or any kind of claim made by a third person. Note: Body fat percentage estimates will vary with the amount of water in the body, and can be affected by dehydration or over-hydration due to such factors as alcohol consumption, menstruation, illness, intense exercise, etc.
  • Page 4: Preparations Before Use

    PREPARATIONS BEFORE USE Inserting the Batteries Open the battery cover on the back of the measuring platform. Insert the supplied AA- batteries as indicated. Note: Be sure that the polarity of the batteries is set properly. If the batteries areincor- rectly positioned the fluid may leak and damage floors.
  • Page 5: Setting And Storing Personal Data In Memory

    SETTING AND STORING PERSONAL DATA IN MEMORY You will receive readings only if data has been programmed into one of the personal data memories or the Guest mode. The monitor can store personal details for up to 4 people. 1. Turn on the Power Press the Set button to turn on the unit (once programmed, tapping a Personal Key turns on the unit.) The unit will beep to confirm activation, the Personal Key numbers (1,2,3,4) will be displayed, and the display...
  • Page 6: Taking Weight And Body Fat Readings

    TAKING WEIGHT AND BODY FAT READINGS 1. Select Personal Data Number Press the Down button to turn on. Use the Up/Down buttons to select your Personal data number. Press the Set button to confirm. (Release the key within 3 seconds or the display will show “Error”.) The unit will beep and the display will show the programmed data.
  • Page 7: Programming The Guest Mode

    3.Recall Function The previous readings of the following features can be obtained using the recall function. ・Weight ・Body Fat % ・Total Body Water % ・Muscle Mass ・Visceral Fat Level To obtain previous readings, press the SET button while the current readings are being displayed. The display will show the previous readings.
  • Page 8: Troubleshooting

    TROUBLESHOOTING If the following problems occur ...then... ・A wrong weight format appears followed by kg, lb, or st-lb. Refer to Switching the Weight Mode on p.2. ・"Lo" appears on the display, or all the data appears and immediately disappears. Batteries are low. When this message appears, be sure to replace the batteries immediately, since weak batteries will affect the accuracy of your measurements.
  • Page 9 Fax: +49 (0)-7031-6189-71 Fax: +33(0)-1-55-24-98-68 www.tanita.de www.tanita.fr Tanita Corporation Tanita Corporation of America Inc. Tanita Health Equipment H.K. Ltd. Unit 301-303 3/F Wing On Plaza 14-2, 1-Chome, Maeno-Cho 2625 South Clearbrook Drive Itabashi-Ku, Tokyo, Japan 174-8630 Arlington Heights, IL 60005 USA...

Table of Contents