Table of Contents
Advertisement
Faults and what to do about them.
en
Display
E:18
E:23
E
9 flashes
:
.
Other displays
Faults and what to do about them.
Faults
Water is leaking out.
No water supply.
Detergent not dispensed.
Washing machine door
cannot be opened.
Programme does not
start.
Detergent solution is not
emptied.
Water not visible in the
drum.
Spin result not satisfac-
tory.
Laundry wet/too damp.
Spin cycle started and
stopped several times.
28
Cause/remedial action
The detergent solution pump is blocked. Clean the detergent solution pump.
■
The drain hose/waste pipe is blocked. Clean the drain hose at the siphon.
■
Water in the base tub, appliance leaking. Turn off the water tap. Call the after-sales
service.
The childproof lock is activated; to deactivate:
Too much foam detected, a rinse cycle has been switched on.
The mains voltage is too low.
Undervoltage in the wash programme.
The programme is extended.
Switch off the appliance, wait for 5 seconds and switch it back on again. If the dis-
play appears again, call the after-sales service.
Cause/remedial action
Attach/replace the drainage hose correctly.
■
Tighten the screw connection of the supply hose.
■
Start/Pause A not pressed?
■
Tap not turned on?
■
Filter blocked? Clean the filter.
■
Supply hose kinked or trapped?
■
Safety function active. Programme stopped?
■
– – – 0 (Rinse hold = without final spin) selected?
■
Can be opened by emergency release only?
■
Start/Pause A pressed or "Ready in" time selected?
■
Washing machine door closed?
■
E Childproof lock activated? To deactivate:
■
– – – 0 (Rinse hold = without final spin) selected?
■
Clean the detergent solution pump.
■
Clean the waste pipe and/or drainage hose.
■
Not a fault – water below the visible area.
Not a fault – the unbalanced load detection system has interrupted the spin
■
because the laundry is unevenly distributed.
Distribute large and small items of laundry evenly in the drum.
Q Easy Iron (depending on the model) selected?
■
Speed selected too low?
■
Not a fault – the unbalanced-load detection system is adjusting the imbalance.
Advertisement
Table of Contents
