Table of Contents
Advertisement
Settings
Setting the boot password
Setting a password with the BIOS enhances protection against viruses and hacking attacks.
On the BIOS screen, tap Security.
The following password settings are available:
• S upervisor Password: This password is required when turning on the device or entering
the BIOS screen. This password allows you to enter the BIOS screen as an administrator.
You can change the BIOS settings.
• U ser Password: This password is required when turning on the device or entering the
BIOS screen. This password allows you to enter the BIOS screen as a user. You cannot
change the BIOS settings. The password will be deactivated automatically if the
supervisor password is removed.
• H DD Password: This password is required to access the hard disk drive (HDD) from
another computer. This password may not be supported depending on the model.
Do not forget your password or expose it to others.
• I f you forget your supervisor password or HDD password, contact a Samsung
Service Centre.
• I f you forget your user password, you can remove it by removing the supervisor
password.
Setting a boot password
To set a user password or HDD password, you must set the supervisor password first.
1
Tap Set Supervisor Password, Set User Password, or Set HDD Password.
2
Enter a password and tap Ok.
The password can be up to 20 characters long.
3
Enter the password again and tap Ok.
4
Tap Save to save the password and restart the device.
62
Advertisement
Table of Contents
