Table of Contents
Advertisement
en Troubleshooting
Fault
The spin result is not satis-
factory. The laundry is too
wet/too damp.
Detergent residue on the
damp washing.
Detergent residue on the dry
laundry.
Water is leaking out at the
water inlet hose.
Water is leaking out at the
water outlet hose.
54
Cause
A low spin speed is selected.
is activated.
Drain pipe or water outlet
hose is blocked.
Drain pipe or water drain
hose is caught or jammed.
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
Unbalance load detection
system is using a reduced
spin speed to eliminate an
unbalance.
Detergents may contain wa-
ter-insoluble substances that
deposit on the laundry.
Detergents may contain wa-
ter-insoluble substances that
deposit on the laundry.
Water inlet hose is not cor-
rectly/securely connected.
The water outlet hose is
damaged.
Troubleshooting
The next time you run a wash cycle,
▶
set a higher spin speed.
Start the Centrifugering pro-
▶
gramme.
Select the programmes that are
▶
suitable for the type of fabric.
→ "Programmes", Page 25
Clean the drain pipe and the water
▶
outlet hose.
Ensure that the drain pipe and wa-
▶
ter drain hose are not kinked or
trapped.
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Start the Centrifugering pro-
▶
gramme.
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Start the Centrifugering pro-
▶
gramme.
Start the Sköljning programme.
▶
Brush out the laundry after washing
▶
and drying.
Connect the water supply hose cor-
1.
rectly. Connecting the water inlet
hose
Tighten the screw connection.
2.
Replace the damaged water outlet
▶
hose.
Advertisement
Table of Contents
