ABB HT567338 Operation Manual page 62

5.3.2
NOTICE
Operating the water
pressure vessel
© Copyright 2017 ABB. All rights reserved.
Maintenance
Cleaning the compressor during
operation
Wet cleaning using external water-pressure vessel (XC3)
Operating state prerequisites for wet cleaning XC3
To be able to carry out a satisfactory cleaning process which has been
tested and is recommended by ABB Turbo Systems, the following pre-
requisites must be fulfilled:
Engine load 50 ... 85%

Start of cleaning cycle in accordance with following description for

wet cleaning operation with XC3.
Operating procedure for compressor wet cleaning with XC3
The operating state prerequisites for compressor cleaning with XC3

must be fulfilled.
Remove sealing plug (X).

Fill vessel with required volume of clean water (see table Cleaning pa-

rameters).
Operation Manual / TPL67-C.. - TPL71-C..
5
5.3 Page 60