Install The Remote Control Batteries; Connect The Antenna Or Cable - Philips 32HFL3330D/27 User Manual

3. Firmly pull the stand from the bottom of the
TV. Place both the stand and bolts in a secure
location for future reinstallation.
For 32HFL3330D/27, security screws are provided to
secure the LCDTV stand to the table top.
Step 3 Connect cables
Connect the antenna cable, AC power cord and all
other devices to the back of the TV as described in
the following sections and in Section 8 Connect devices.
Step 4 Secure the VESA-compatible wall
bracket to the TV
Warning
B
Only use the specified bolts (M6 x 10mm)
to secure the VESA-compatible wall
bracket to your TV. The specified bolts are
designed to match the weight of your TV.
Note
D
Depending on your VESA-compatible wall
bracket, you may need to separate the mounting
plate from the wall bracket for easier installation.
Refer to your VESA-compatible wall bracket
documentation for instructions.
EN-8
4.3 Install the remote control
1. Open the battery cover on the back of the
remote control.
2. Insert the 2 batteries supplied. Make sure the
+ and - ends of the batteries line up correctly.
(inside of case is marked).
3. Close the cover.
4.4

Connect the antenna or cable

This section describes how to connect your TV to
an antenna, cable, Direct Broadcast Satellite, and to a
cable receiver box.
AV 1
HDMI 1
HDMI 2 / PC IN
AV 2
Connect to an antenna
Any DTV programs that are broadcast in your
area can be received for free through an antenna
connection.
AV 1
HDMI 1
HDMI 2 / PC IN
AV 2
batteries
CABLE
75 Ω
75 Ω
SATELLITE