Programmes - AEG L7FEC946U User Manual

Table of Contents

Advertisement

18
www.aeg.com
• Press the On/Off button for a few
seconds to activate or the deactivate
the appliance.
• Turning the programme dial in
another position.
A small laundry load helps to
reach better results.
8.8 Delay Start
With this option you can delay the start of
a programme in a more convenient time.
Touch the button repeatedly to set the
required delay. The time increases by
steps of 30 minutes up to 90' and from 2
hours up to 20 h.
After touching the Start/Pause button,
the display shows the indicator
the selected delay time and the
appliance begins the countdown.
8.9 Time Save
With this option you can decrease the
programme duration.
• If your laundry is normally or lightly
soiled, it may be advisable to shorten
the washing programme. Touch this
button once to decrease the duration.
• In case of smaller load, touch this
button twice to set an extra quick
programme.
The display shows the indicator
This option can also be used
to shorten the steam
programme duration.
8.10 Skipping phase button
(Options)
By touching this button you can set:

9. PROGRAMMES

9.1 Programme Chart
Washing programmes
Programme
Washing programmes
• Rinse only at first touch. The washing
• Spin only at second touch. The
• Drain only at third touch. The
and
8.11 Pods®
Touch this button to activate or
deactivate the Pods® option .
When activated the relevant indicator is
on.
Follow the Pods manufacturer's dosage
and storage recommendations.
Put maximum two tablets or single-dose
detergents in the Pods® compartment in
the detergent dispenser drawer.
The option remains active also for next
cycles until it is deactivated and if it is
selectable with the set programme.
.
8.12 Start/Pause
Touch the Start/Pause button to start,
pause the appliance or interrupt a
running programme.
Programme description
programme starts from the rinsing
phase by skipping the wash phase.
All set options (except
permanent extra rinse)
are deselected
automatically.
appliance skips wash and rinse
phase.
appliance performs only the drain
phase.
At firth touch the appliance
proposes the default setting
of the washing programme
again.

Advertisement

Table of Contents
loading

Table of Contents