Advertisement
Quick Links
RE80
Receiver Main and Relay Unit
T.220.001.524
WARNING !
The device should be opened in an ESD protected
environment with respect to the following
precautions : discharge yourself from electros-
tatic loads by touching a grounded conductive surface
before opening the unit.
Disassemble the device :
1. Remove the 434 MHz antenna
2. Remove and keep the TNC adap-
tor (needed to connect the new
antenna)
3. Remove the 4 screws "torx" on the
bottom side
4. Open the housing
3
1
1
2
This package contains all pieces to trans-
form an NC4 working at 434MHz to the new
TeleAlarm system working at 868.8 MHz.
868.8MHz Antenna :
Transceiver Board @ 868.8MHz:
2
Remove the bottom housing :
1. Open the bottom housing
2. Unplug the internal battery
1
2
Advertisement
Related Manuals for KATEK TeleAlarm RE80
Summary of Contents for KATEK TeleAlarm RE80
- Page 1 This package contains all pieces to trans- RE80 form an NC4 working at 434MHz to the new TeleAlarm system working at 868.8 MHz. Receiver Main and Relay Unit 868.8MHz Antenna : T.220.001.524 Transceiver Board @ 868.8MHz: WARNING ! The device should be opened in an ESD protected environment with respect to the following precautions : discharge yourself from electros- tatic loads by touching a grounded conductive surface...
- Page 2 Exchange the RF board at 434MHz by Close the housing : 868.8MHz : 1. Replug the battery connector 2. Close the housing using 4 screws 1. Remove the screw how maintains the RF board 2. Keep out the RF board carefully 3.