Contents 1 Important Safety Notice 2 Your Docking Entertainment System Introduction What’s in the box Overview of the main unit Overview of the remote control 3 Get started Install batteries Prepare the remote control Connect power Set time and date Turn on 4 Play Play from iPod/iPhone...
1 Important Safety This ‘bolt of lightning’ indicates uninsulated material within your unit may cause an electrical shock. For the safety of everyone in your household, please do not remove product covering. The ‘exclamation point’ calls attention to features for which you should read the enclosed literature closely to prevent operating and maintenance problems.
Notice This product complies with the radio interference requirements of the European Community. Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. ) or...
2 Your Docking Entertainment System Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this unit, you can enjoy audio from the iPod, iPhone, other audio devices, or the radio. The radio, iPod, or iPhone can be set as the alarm timer.
Overview of the main unit DATE SLEEP SET TIME PROG ALARM 1 /DATE • View the clock time and date. b SLEEP • Set the sleep timer. • Search within an audio file. • Tune to a radio station. /SET TIME/PROG • Set the clock and date. •...
• Skip to the previous/next audio file. • Select a preset radio station. • Adjust time. l VOL +/- • Adjust volume. m Dock for iPod/iPhone • Load an iPod/iPhone. n FM antenna • Improve FM reception. o MP3-LINK • Jack for an external audio device. Overview of the remote control POWER...
Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the rear of the apparatus. Write the numbers here: Model No.
Open the battery compartment. Insert 2 x R6/UM-3/AA size batteries with correct polarity (+/-) as indicated. Close the battery compartment. Prepare the remote control Caution • Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire. For first-time use: Remove the protective tab to activate the remote control battery.
Turn on Press POWER. » The unit switches to the last selected source. Switch to standby Press POWER again to switch the unit to standby mode. The time and date (if set) appear on » the display panel. 4 Play Play from iPod/iPhone You can enjoy audio from iPod/iPhone through this unit.
Press iPhone/iPod to select iPod/iPhone source. » The connected iPod/iPhone plays automatically. • To pause/resume play, press • To skip to a track, press • To search during play, press and hold / , then release to resume normal play. •...
Repeat steps 5-6 to set the alarm volume. • If you set iPhone/iPod playlist as the sound source, you must create a playlist in iTunes called “PHILIPS” and import it to your iPhone/ iPod. • If no playlist is created in the iPod/iPhone or there is no song in the playlist, the unit will wake to songs in the iPod/iPhone.
Activate and deactivate the alarm timer Press ALM 1 or ALM 2 repeatedly to activate or deactivate the timer. » If the timer is activated, [ AL2] is displayed. If the timer is deactivated, [ » AL2] disappears. Repeat alarm When the alarm rings, press BRIGHTNESS/REP ALM.
1.36 kg requesting service. If the problem remains unsolved, go to the Philips web site (www. philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.