Intended Use; Product Specification; Assembly And Installation Instructions - 4mount Nintendo Switch wall mount User Manual

Wall holder manual
EN
Nintendo Switch™ 4mount

1. Intended use

The holder is intended for mounting Nintendo Switch™ console on a wall. In caring for your safety, we
inform that the holder should be mounted by a person with appropriate skills and the holder itself should be
used according to its intended use. Mounting elements included are intended only for mounting and
installation on walls made of brick, concrete or solid wood. In the case of walls made of plasterboard, we
recommend mounting and installation on screw anchors for gypsum blocks – not included in the set.

2. Product specification

Product dimensions
Product weight
Max. load
Distance between the equipment installed and
the wall
Composition of the set*
* The manufacturer shall not be liable for damage caused by inappropriate mounting and installation of the
holder or for use of parts not included in the set.

3. Assembly and installation instructions

1. Choose where you want to place your console.
2. Apply the holder to the wall, align it horizontally and mark the place for drilling holes. 2 holes are for
mounting with screw anchors included. Put down the holder, drill 2 holes in the wall, each with the diameter
of 6 mm and 40 mm deep. Then place the screw anchors in each of the holes.
3. Apply the holder again to the wall and place screws in the holes. Level the holder and tighten all the
screws thoroughly. Check the level and if the holder holds firmly.
4. Place your console as presented on the pictures.
17,2 x 11,1 x 6,9 cm (WxHxD)
0,4 kg
up to 5 kg
1 cm
1 console holder, 2 mounting screw anchors, a
manual