CHECKOUT PROCEDURE FOR SWITCHES
Disconnect the lead wires from the switches and check the continuity of the switches, connecting an ohm-meter to its
terminals.
SWITCH
Primary Interlock
Connect an ohm-meters leads to terminals "COM"
and "NO" of switch
Door Sensing
Connect an ohm-meters leads to terminals "COM"
Interlock monitor
and "NC" of switch
CAUTION : After checking the switches, make sure that the interlock monitor switch is properly connected according to
the CIRCUIT DIAGRAM on page 4 (Continental version).
CHECKOUT PROCEDURES
-9-
DOOR OPEN DOOR CLOSE