Download Print this page

RAKwireless Creator Pro Manual

How to use dashbutton's jtag pin as digital io

Download this manual

1. Power with Creator Pro

DashButton_V12

DashButton_V1.1

When power on, the dashButton connect to wifi, and will print like below:

【2017-09-22 18:30:56:920】Connected to wifi

SSID: RAK_2.4GHz_1

IP Address: 192.168.70.146

signal strength (RSSI):-45 dBm

【2017-09-22

18:30:57:995】key1

【2017-09-22 18:30:58:280】

Connect to Server successful!

/press.php/?id=1

HOW TO USE DASHBUTTON'S JTAG PIN AS DIGITAL IO

Page 1 When power on, the dashButton connect to wifi, and will print like below: 【2017-09-22 18:30:56:920】Connected to wifi SSID: RAK_2.4GHz_1 IP Address: 192.168.70.146 signal strength (RSSI):-45 dBm 【2017-09-22 18:30:57:995】key1 【2017-09-22 18:30:58:280】 Connect to Server successful! /press.php/?id=1 Copyright © Shenzhen Rakwireless Technology Co., Ltd...
Page 2 D21-D25 as digital pin, then it will fail to program the dashButton using creator pro any more. CREATOR-Arduino-SDK/hardware/libraries/Http/examples/DashButtenSampleCode/DashButtenSam pleCode.ino CREATOR-Arduino-SDK/hardware/cores/arduino/wiring_digital.c Copyright © Shenzhen Rakwireless Technology Co., Ltd...
Page 4 2. Wait some time until the four leds turn red, it means dashButton connect to network successfully. 3. Then if you push one key down, the corresponding led will light blue, it means dashButton is communicate with cloud server. Copyright © Shenzhen Rakwireless Technology Co., Ltd...