Lenovo ThinkPad 1 Gen Z16 User Manual page 58

The M.2 solid-state drive is sensitive. Inappropriate handling might cause damage and permanent loss of
data.
When handling the M.2 solid-state drive, observe the following guidelines:
• Replace the M.2 solid-state drive only for upgrade or repair. The M.2 solid-state drive is not designed for
frequent changes or replacement.
• Before replacing the M.2 solid-state drive, make a backup copy of all the data that you want to keep.
• Do not apply pressure to the M.2 solid-state drive.
• Do not touch the contact edge or circuit board of the M.2 solid-state drive. Otherwise, the M.2 solid-state
drive might get damaged.
• Do not make the M.2 solid-state drive subject to physical shocks or vibration. Put the M.2 solid-state drive
on a soft material, such as cloth, to absorb physical shocks.
For access, do the following:
1. Disable the built-in battery. See "Disable Fast Startup and the built-in battery" on page 47.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn the computer over.
4. Remove the base cover assembly. See "Base cover assembly" on page 48.
Removal procedure (for ThinkPad Z13 Gen 1)
Notes:
• A mylar film might cover the M.2 solid-state drive bracket. To access the M.2 solid-state drive, peel off the
mylar film first. Do not damage the mylar film and attach it in place after installation.
• There might be thermal pads on the top and the bottom of the M.2 solid-state drive. Ensure that the
thermal pad under the M.2 solid-state drive stays in its place after replacing the drive.
50
Z13 Gen 1 and Z16 Gen 1 User Guide